A-A-52415A(AT)
a. Title, number, and date of this CID.
b. Clamp size and PIN (see figure 1, 2.3 and 6.4).
c. If required, the specific issue of individual documents referenced (see 6.1).
d. Selection of applicable level and packaging requirements (see 5).
6.3 Cross-reference data. Clamp assemblies conforming to this document are interchangeable/substitutable with clamps conforming to MS53041B(AT).
6.4 Part identification number (PIN). The PINs to be used for clamps acquired by this CID are created as follows:
A 52415- X
X- Dash no. (see figure 1)
52415- CID number
A- Prefix letter to indicate CID
6.5 Metric product. Clamps that are manufactured to metric dimensions will be considered on the following basis:
a. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, provided they fall within specified tolerances using conversion tables contained in the latest revision of IEEE/ ASTM-SI10, and all other requirements of this CID are met.
b. If a product is manufactured to metric dimensions and those dimensions exceed the tolerances specified in the inch-pound units, a request should be made to the contracting officer to determine if the product is acceptable.
c. The contracting officer has the option of accepting or rejecting the product.
Custodian:
Army-AT
Preparing Activity:
Army-AT
(Project 2990-2010-001)
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST database at https://assist.daps.dla.mil/.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business